fourlen参与话题 2消息总数 4

fourlen 2026-06-17 20:39:47 ↗ Hyperliquid eth_sendRawTransaction调用延迟讨论与基准测试邀请

Thanks a lot for the answer. But I don't think that's the case. First of all, I have my own node, running in Tokyo. When I'm going to send tx, I broadcast it to 5-6 public rpcs , + my own (all in parallel ofc). 300-500 is the average LOWEST latency across all rpcs I'm broadcasting my tx to. Since there's no tls over local node, there's also no tls handshake latency. And yes, I'm on small blocks. Have you faced with the same issue? What's yours average RTT on eth_sendRawTransaction?

Thanks a lot for the answer. But I don't think that's the case. First of all, I have my own node, running in Tokyo. When I'm going to send tx, I broadcast it to 5-6 public rpcs , + my own (all in parallel ofc). 300-500 is the average LOWEST latency across all rpcs I'm broadcasting my tx to. Since there's no tls over local node, there's also no tls handshake latency. And yes, I'm on small blocks. Have you faced with the same issue? What's yours average RTT on eth_sendRawTransaction?

fourlen 2026-06-17 00:27:39 ↗ Hyperliquid HEVM链交易速度慢与Gas限制过高问题

Well, I mean I just need my tx to be included in the next block, but when eth_sendRawTransaction takes 800ms in some cases, it's hard to achieve..

Well, I mean I just need my tx to be included in the next block, but when eth_sendRawTransaction takes 800ms in some cases, it's hard to achieve..

fourlen 2026-06-17 00:22:30 ↗ Hyperliquid HEVM链交易速度慢与Gas限制过高问题

Hi everyone! I'm building a latency-sensitive app on HyperEVM and I've run into an issue: eth_sendRawTransaction usually takes 300–500ms, sometimes even 700–800ms. Why is that, and how can I reduce the latency?

Hi everyone! I'm building a latency-sensitive app on HyperEVM and I've run into an issue: eth_sendRawTransaction usually takes 300–500ms, sometimes even 700–800ms. Why is that, and how can I reduce the latency?

fourlen 2026-06-06 18:14:54 ↗ Hyperliquid

Hi, how can I find out which L1 block my HypereVM transaction was included in?

Hi, how can I find out which L1 block my HypereVM transaction was included in?